Customer:
Carleton University

Challenge: The label needed to wrap around a cable as identification, the ends sticking together, but not adhere to the cable, i.e. be able to slide along it. The label was to be printed by thermal transfer technology, using a random database, so it had to be prepared in rolls.

Solution: The label itself could not have been simpler, but its structure on the adhesive side required a certain intricacy in manufacture.

When removed from the roll, the label needed the adhesive on the middle third of its length to be masked. The ends could then stick together, leaving a non-stick loop in the centre, (rather like a bandaid in form.)

Label Innovation (LINC) developed a die that would cut to two different levels. This allowed the overall label shape to be done by a kiss-cut, while an anvil cut was made through the face, adhesive and liner in the middle, between the labels on the roll. Linear backslitters were then used to cut the liner in the middle third of each label, so it would remain on the label, covering the adhesive in that area. Understanding what the customer wants the label to do allows LINC to ensure that the label will work in its application.

Back to Solution Showcase